modifying and bending the TR-66, part 1
The TR-66 is an old Roland rhythm machine, containing only preset rhythms, and having no sound editing capability. However, it contains the same or similar circuits as a more well-known Roland machine, the CR-78. This is the first in a series of posts which will document my modifications of this old beatbox. The first bend I’m documenting in these posts is something I found awhile ago, but haven’t made permanent yet. I’ve decided to go the breakout box route, to avoid having to drill multiple holes in the case. It’s sort of a strange design, where the outer wooden casing is a box open in the front and back. Four screws come out of the bottom, and then the innards (which are built on a metal frame with the front & back panels attached) slide out.
I should note that conventional wisdom says it’s a bad idea to circuit bend 120 VAC devices such as this, and that I make no guarantee that attempting to do this with your TR-66 won’t cause damage.
Taking a look inside, you will see trim pots for setting many sound parameters- and handily, most are even labeled. There are a total of 8 trim pots on this board- the ones labeled “103″ are 10k pots, the ones labeled “501″ are 500 ohm. I’m thinking of trying 1k pots for those, since 500 ohm seems to be harder to find.
You may also notice that it seems the outputs for each drum sound are labeled on the board- this should make it easily possible to include level adjustments for each sound, as well as other mods such as individual outputs if one were so inclined.
The first order of business will be making a hole to thread the wires for the breakout box through. I’ve decided to make the hole in the rear panel- partly because that seems “right”, but mostly because the case design makes that the easiest way to go. As the picture shows, there’s plenty of open space back there.
I would like to note that it was a lot harder to drill through the relatively thin plate than I thought it would be. I used a fairly small drill to make a pilot hole, then followed up with a step drill to get it to the size I wanted. I went with a pretty big hole, since there are several pots I plan to replace, as well as a couple of other mods.
The first bend/mod is what I call the “distortion mod” – connecting a pot between the two points shown in the picture below gives you a sort of distortion effect that increases as you turn the knob. I used a 10k pot, because that’s what I had on hand.
the solder points for the distortion bend
That’s it for the first installment (because I’m out of unspoken-for parts). More to come, though it could be awhile as this is pretty low on my priority list.
if I were the sort to listen to this kind of crap, I probably wouldn't have a job right now
Interesting. I speak math/science (geek) although my branch is more in the medical and physics. I’m hoping to do my research in the receptors throughout the body that recieve and respond to its billions of stimulus that life offers. its a slow science because you can find ways to block them also, which could cure addicts and completely take away pain naturally. But there is no funding since pharms would die. You might appreciate this, look up Les Lily in the encyclopedia of who;s who scientists. Since then he’s had jobs where he gets in suits and spends a couple hours a day working on chips and gets payed rediculously. Thats my father.
That’s cool- those areas interest me as well (especially physics), but you know how it goes, so much science, so little time. :)